About STS(Single Tube System)
The STS system may also be referred to as the BTA system in the deep hole drilling process.
A large volume of coolant is pumped under high pressure to the cutting area in the workpiece.
Chips are then forced out through the drill tube at the back.
Drilling depths of 10 to 300 times the diameter of the hole can be achieved.
Solid Drilling
Only one operation necessary to obtain required hole diameter.
8.00mm to 500.00mm (actual result) diameter range available.
Brazed, Indexable and Direct Mount tooling available.
Counterboring
This process is used to open up a pre-bored hole to obtain a more exact diameter and to machine a precise quality hole.
Diameter range from ø18.90mm.
Brazed and Indexable tooling available.
Trepanning
Trepanning requires less power than solid drilling applications. Trepanning also leaves a core which can be used for material analysis or production of other parts.
Diameter available from ø81mm.
